|
ASTM-C113
|
1993
|
Standard Test Method for Reheat Change of Refractory Brick R(1998)
|
|
ASTM-C1130
|
1990
|
Standard Practice for Calibrating Thin Heat Flux Transducers R(2001)
|
|
ASTM-C1131
|
1995
|
Standard Practice for Least Cost (Life Cycle) Analysis of Concrete Culvert, Storm Sewer, and Sanitar
|
|
ASTM-C1133
|
1996
|
Standard Test Method for Nondestructive Assay of Special Nuclear Material in Low-Density Scrap and W
|
|
ASTM-C1134
|
1990
|
Standard Test Method for Water Retention of Rigid Thermal Insulations Following Partial Immersion R(
|
|
ASTM-C1135
|
2000
|
Standard Test Method for Determining Tensile Adhesion Properties of Structural Sealants
|
|
ASTM-C1136
|
2000
|
Standard Specification for Flexible, Low Permeance Vapor Retarders for Thermal Insulation
|
|
ASTM-C1137
|
1997
|
Standard Test Method for Degradation of Fine Aggregate Due to Attrition
|
|
ASTM-C1138
|
1997
|
Standard Test Method for Abrasion Resistance of Concrete (Underwater Method)
|
|
ASTM-C1139
|
1990
|
Standard Specification for Fibrous Glass Thermal Insulation and Sound Absorbing Blanket and Board fo
|
|
ASTM-C114
|
2000
|
Standard Test Methods for Chemical Analysis of Hydraulic Cement
|
|
ASTM-C1140
|
1998
|
Standard Practice for Preparing and Testing Specimens from Shotcrete Test Panels
|
|
ASTM-C1141
|
2000
|
Standard Specification for Admixtures for Shotcrete
|
|
ASTM-C1142
|
1995
|
Standard Specification for Extended Life Mortar for Unit Masonry R(2001)
|
|
ASTM-C1144
|
1989
|
Standard Test Method for Splitting Tensile Strength for Brittle Nuclear Waste Forms R(1997)
|
|
ASTM-C1145
|
2002
|
Standard Terminology of Advanced Ceramics
|
|
ASTM-C1146
|
1996
|
Standard Guide for Prefabricated Panel Insulation Systems for Ducts and Equipment Operating at Tempe
|
|
ASTM-C1147
|
2001
|
Standard Practice for Determining the Short Term Tensile Weld Strength of Chemical-Resistant Thermop
|
|
ASTM-C1148
|
1992
|
Standard Test Method for Measuring the Drying Shrinkage of Masonry Mortar E(1997) R(1997)
|
|
ASTM-C1149
|
2002
|
Standard Specification for Self-Supported Spray Applied Cellulosic Thermal Insulation
|
|
ASTM-C115
|
1996
|
Standard Test Method for Fineness of Portland Cement by the Turbidimeter
|
|
ASTM-C1152
|
1997
|
Standard Test Method for Acid-Soluble Chloride in Mortar and Concrete
|
|
ASTM-C1153
|
1997
|
Standard Practice for Location of Wet Insulation in Roofing Systems Using Infrared Imaging
|
|
ASTM-C1154
|
2000
|
Standard Terminology for Non-Asbestos Fiber-Reinforced Cement Products
|
|
ASTM-C1155
|
1995
|
Standard Practice for Determining Thermal Resistance of Building Envelope Components from the In-Sit
|
|
ASTM-C1156
|
1995
|
Standard Guide for Establishing Calibration for a Measurement Method Used to Analyze Nuclear Fuel Cy
|
|
ASTM-C1158
|
2001
|
Standard Practice for Installation and Use of Radiant Barrier Systems (RBS) in Building Construction
|
|
ASTM-C1159
|
1998
|
Standard Specification for Sulfur Polymer Cement and Sulfur Modifier for Use in Chemical-Resistant,
|
|
ASTM-C1160
|
1997
|
Standard Specification for Chemical-Resistant Carbon Brick
|
|
ASTM-C1161
|
2002
|
Standard Test Method for Flexural Strength of Advanced Ceramics at Ambient Temperature
|
|
ASTM-C1162
|
1990
|
Standard Test Method for Loose Density of Asbestos R(1999)
|
|
ASTM-C1163
|
1998
|
Standard Test Method for Mounting Actinides for Alpha Spectrometry Using Neodymium Fluoride
|
|
ASTM-C1164
|
1992
|
Standard Practice for Evaluation of Limestone or Lime Uniformity From a Single Source E(01-nov-1997)
|
|
ASTM-C1165
|
1990
|
Standard Test Method for Determining Plutonium by Controlled-Potential Coulometry in H2SO4 at a Plat
|
|
ASTM-C1166
|
2000
|
Standard Test Method for Flame Propagation of Dense and Cellular Elastomeric Gaskets and Accessories
|
|
ASTM-C1167
|
1996
|
Standard Specification for Clay Roof Tiles
|
|
ASTM-C1168
|
2001
|
Standard Practice for Preparation and Dissolution of Plutonium Materials for Analysis
|
|
ASTM-C1169
|
1997
|
Standard Guide for Laboratory Evaluation of Automatic Pedestrian SNM Monitor Performance
|
|
ASTM-C117
|
1995
|
Standard Test Method for Materials Finer Than 75-Micrometers (No. 200) Sieve in Mineral Aggregates b
|
|
ASTM-C1170
|
1991
|
Standard Test Methods for Determining Consistency and Density of Roller-Compacted Concrete Using a V
|
|
ASTM-C1171
|
1996
|
Standard Test Method for Quantitatively Measuring the Effect of Thermal Shock and Thermal Cycling on
|
|
ASTM-C1172
|
1996
|
Standard Specification for Laminated Architectural Flat Glass E(1996)
|
|
ASTM-C1173
|
1997
|
Standard Specification for Flexible Transition Couplings for Underground Piping Systems
|
|
ASTM-C1174
|
1997
|
Standard Practice for Prediction of the Long-Term Behavior of Materials, Including Waste Forms, Used
|
|
ASTM-C1175
|
1999
|
Standard Guide to Test Methods and Standards for Nondestructive Testing of Advanced Ceramics
|
|
ASTM-C1176
|
1992
|
Standard Practice for Making Roller-Compacted Concrete in Cylinder Molds Using a Vibrating Table R(1
|
|
ASTM-C1177
|
2001
|
Standard Specification for Glass Mat Gypsum Substrate for Use as Sheathing
|
|
ASTM-C1178
|
2001
|
Standard Specification for Glass Mat Water-Resistant Gypsum Backing Panel
|
|
ASTM-C1179
|
1991
|
Standard Test Method for Oxidation Mass Loss of Manufactured Carbon and Graphite Materials in Air R(
|
|
ASTM-C118
|
1999
|
Standard Specification for Concrete Pipe for Irrigation or Drainage
|
